question

[private]

I new to this air ride stuff but someone told me to get a 1 port tank because i want manifold valves(4 way valves) because to lazy to plumb 2 valves together and mount them in the tank' s port. But my question is why can' t i use a a 8 port tank using a 4 way valves.

[darren@ridetech.com]

Which valves are you going to run?

[private]

1. Okay how many different fittings are there because i am not getting a kit i am peiceing everything together for cheaper at ebay not used new products thou, so my questions is how many and what kind of fittings i' ll need throughout the installations.

2. Would my local hardware store have or sell all the fitings i' ll need throughout the installations


3. Since i am going to mount the valves at or in the tank' s ports i' ll need 2 plumb 2 valves together what fitting would i need to do that, also can i go to the hardware stre in the plumbing section and would they plumb it or me and how much( i don' t think any one would know the answer to the how much and will they plumb it for me phrase).


4. What are the fittings for, How do i knon which fittings goes to which part in the setup, maybe i can try all the fittings until they fit.

5. What are relay circuit for


6. What would happen if i don' t use a relay circuit

7. What depends on if i need a relay circuit or not.

8. A pressure switch that i am buying has 2 wires one id the power wire to the battery and the other that send out power goes to what .




9.For the pressure switch has 2 wire one to connect to the batt is that right and the other is to the relay but can someone show me where on the relay that wire suppose to go to.


10. Does the relay siwtch require any wiring like power wire or what and how you hook it up to the compressor.

[darren@ridetech.com]

Man, you have alot of good questions there, but I still need to know what products you are using to answer them. You should be able to go to the local fastener store and get alot of the fittings. Also check a semi truck shop, they use the same ones. Just make sure the fittings are DOT approved.