Ride Pro E pressure sending unit

[TucNwhl NC Ohio]

One of my Ride Pro E pressure sending unit is throwing a false reading to the LCD display. It will show the correct pressure then go up to the ride pros default of 170psi. I can' t have 170psi cause the pressure switch is only a 150psi. Connections seem good at the box and the sending unit, all wires are loomed from the box to the sending unit. I have yet to tear into it to see if there is something clogging the tiny hole on the sending unit or might be floating around in there.

Could water in the system cause a false reading? It has a water trap on the system but didn' t for the first couple weeks.

Any suggestions on what it might be???

Casey Jones
Negative Camber//Ohio\\

[darren@ridetech.com]

It is probably a bad ground at the sending unit or a bad sending unit. Try attaching a ground wire directly to the sending unit housing.