Robert
11-20-2004, 01:03 PM
I' m having trouble programming my Rideproe. I talked to someone at the shop, and they told me to have the dip switches in the up position to program it, (no remote) and when done programming it, to switch the dip switches to the down position. I have done that, and the pressures are no where close to where I have set the program, anybody have any ideas... is there any way to erase a previous program? It seems like the program is doing the same thing as it did before, overinflating and then bleeding down, but too far apparantly. Any help anyone could give me would be appreciated. I have the bracket for the senders isolated from the frame with rubber, and have a dedicated ground running straight to the battery off of the sender bracket.