S10 wish bone

[goofball200]

Ok I am looking at buying the wishbone rear kit for the s10. it says i dont have to cut into the frame for anything. I have seen a few trucks that have a 2 inch c-notch with that set up. Is there any mods i would have to do to get it to sit down in there? I would think that if i threw like a 1 inch or 2 inch lowering block in it should work. but any help would be appreciated.

[darren@ridetech.com]

We havn' t tried that yet but some customers have. I know there is a possible driveshaft to gas tank crossmember issure. Also you will need to make sure the bag doesn' t collapse below minimum spec. and the same with the shocks. Also drive line angle need to be checked at ride height.