? about ride pro e computer auto ride height

[triplecap]

I configured the ride height in the ART Ride Pro E computer to automatically adjust the car to ride height at " key-on" or with the button on the key fob. My problem is that it raises the rear of the car before attempting to raise the front. My ride height is approx 70 psi in the rear and 105 psi in the front. The computer raises the rear of the car no problem, but there' s not enough psi left in the tanks (2 five gallon tanks) to raise the front properly.

Is there anything that can be done to fix this (other than switch the harness around so that the front is the back, and the back the front!)?
Not sure what psi the 1 400C compressor is filling the tanks to. What is the default psi to which the big red system fills the tanks and at what psi are the compressors supposed to kick back in? I will be getting a 2nd compressor soon.
Running an add' l tank is not an option.

Thanks in advance!
Eric
www.cardomain.com/id/triplecap (it' s the 63' wagon in question)

[darren@ridetech.com]

Two 5 gal. tanks should be plenty to lift that car to ride height in one shot. Actually one 5 gal. is enough. I just did a 64 a couple weeks ago and one 5 was plenty. About the same pressures too. The comp. should kick off at 150psi. But if you are running two 5 gal. tanks on one Viair 400 the comp. might thermo out before it gets to 150 psi. It the pump get too hot it will automatically shut off. Another comp. might be the answer.