PDA

View Full Version : question for 1959 Ford


Cruizer12
03-12-2006, 11:01 PM
I am thinking of putting and air ride setup on my 1959 Fairlane 500 4 door sedan, and want to go as low as possible do you have a complete system for this car if so how much

darren@ridetech.com
03-13-2006, 11:37 AM
Nothing specific. I have a universal kit that will work with some minor fab work. Around $2000 will get you a complete kit.

Cruizer12
03-14-2006, 12:49 PM
ok is it like the one the used on the 1960 - 1963 Ford Galaxie, because that is what I am looking for if it works on my car Which is 1959 Ford Fairlane 500 Galaxie but a 4 door Sedan, can it be ordered seperately like rear setup and the front setup an then the tank system if not what would be the part number for the complete system so I can save up and order at a later time........

darren@ridetech.com
03-14-2006, 04:45 PM
The 59 is different. Does it have leafs in the back or coils?

Cruizer12
03-14-2006, 09:21 PM
it has leafs but if possible I want to do away with them

darren@ridetech.com
03-15-2006, 10:42 AM
We have the weld on 4 links like this triangulated one.
http://www.ridetech.com/productinfo/air4link.asp

Then just use the ARI1001 and S1000 universal kits for the front.

Cruizer12
03-15-2006, 12:34 PM
So if I go with kits ARI1001, S1000, for the front and ARS13500 for the rear. I can go without the original leaf springs and it will be a complete air bag system. what about air tank and controller

darren@ridetech.com
03-15-2006, 06:05 PM
ARC4100e
http://www.ridetech.com/productinfo/rideproe.asp

Cruizer12
03-15-2006, 08:30 PM
So these are the parts that I will need to setup my car that will work

ARI1001
S1000
ARS13500
ARC4000e

darren@ridetech.com
03-16-2006, 11:42 AM
;)

Cruizer12
03-16-2006, 11:49 AM
OK, how much modification will I need to do with this setup, should I seek a professional

Cruizer12
03-16-2006, 11:55 AM
Also would the ABAR20400 work on my car, although it is a 1959 Fairlane 500 Galaxie 4 door Sedan

darren@ridetech.com
03-16-2006, 12:43 PM
I really don' t know how much work is required, we have never done one. Where are you from?

Cruizer12
03-16-2006, 09:40 PM
Tucson Arizona

darren@ridetech.com
03-17-2006, 10:22 AM
http://www.ridetech.com/displaydealers.asp?region=AZ&regionname=Arizona
I know Tito' s and Porter Built fairly well, either one of them could handle it.

Cruizer12
03-17-2006, 11:58 AM
yes, but they are 100 miles from here or so