E2 start-up

[Mikec1231]

I just finished my new air ride install with the new e2 system. I do not have ride height sensors. The compressor filled the tanks, shut off at 150 psi. If I then push the + buttons on the controller nothing happens to any of the 4 corners. Can someone tell me how to manually raise (with the air) the corners so that I can pre-set. I have the ARC4000E2 Instructions but if you have never used this system, it is lacking some detail.
Please help.
Mike

[phill_e7]

Just installed the same exact system yesterday. Didn' t have a problem with raising or lowering. Couple things you might want to check if you haven' t already.
-When you press the " airride logo" on the control does the display light up?
-Do you have it wired to the ignition, (correctly)? If so do you have the key turned on?
I have my system directly wired to the battery right now (red & yellow to the positive) because I am waiting for a new wire harness. You may want to try this for now until you get used to it. Just make sure your all of your " grounds" are good so you don' t nuke anything.

[darren@ridetech.com]

If the display is reading the pressures then you should be able to +/- button to change the air pressure in the air spring. You do not have to program it first. I would check the ground straps at the air valves.