Air leaks?

[Sean Higgins]

I' m having a problem with all 4 corners leaking down. Does anyone have a good place to start looking for leaks?

[Paint Slinger]

Make sure all your airline ends are cut nice and square. Then check the sending units. Those were the main sorce of air leaks when I first installed my system. If that doesn' t cure it get some soapy water and start spraying it on the fittings. If they are blowing bubbles then they are leaking. Good luck.

[CustomChevS10]

take some soapy water and spray it on the fittings. If it bubbles then you have a leak there.

[SpArX]

Sounds like a tank leak if all four corners are leaking at the same time. By tank leak is any leak going from the tank out, like the tank to the control valves, tank to solenoids and tank to compressor. I had that leak once and it was my o-ring near the check valve for my compressor, I replaced that line and have a leak free system now.

[Sean Higgins]

Thanks for the suggestions guys.

[1badPT]

check to make sure all your hoses are pushed in hard into the fittings. you can check with soapy water. check your threaded connections also.

[Sean Higgins]

Well now only 1 corner leaks down. It was leaking from the sensors. Now I have to hunt down one leak. Thanks for all your advice guys!