Darren>> front coolride question

[clynt11]

I am installing my coolride kit but have run into a problem.

1- On mounting the upper bracket i dont have enough room in between my a arms enough to drill the back two holes. Do i have to take my lower control arm completely off or what? I even went and bought a dewalt low profile right angle drill but with the drill bit in it it is still to big to get in between the control arms.

[MattM1683]

I had to rent a " right angle drill" and the drill bit I used seemed to be fine. Once I got the right angle drill, everything went smoothly. Look around for smaller drill bits that are thick enough for the holes

-matt m-

[clynt11]

Did you take off the a arm or spindle for a litlle extra clearence or what?

[darren@ridetech.com]

You might have to remove the control arm.

[MattM1683]

i removed the brake harware, spindle, and dropped the lower a arm as far as it could go down. and.......used right angle drill. If your having trouble, maybe remove the a-arms

-matt m-