question on what I should use

[thomas]

I am getting ready to redo a 1973-77 ford truck. I' d like to put bags on it, so I would be able to lower it, but also raise it close to factory height, But I' m not sure what I should use for bag wise and all. Any suggestions/comments that would be helpful, I' m all ' ears' . Thank you.

[darren@ridetech.com]

If you are going to keep factory height you could use one of our universal kits. It will require some fab. to attach the bag to the I beam. It will allow you to lower the truck about 3" when deflated.

[thomas]

it doesn' t have to be factory height, but I would like to lower it and raise it up, close to factory height. what is the cost on the universal kits?

[darren@ridetech.com]

Have you thought about using a Mustan II front cross member. It would work so much better. I believe Fatman Fabrication has one for that truck. I would at least look into it before trying to use the I Beams.