'61 Buick shockwave question

[lowsmoothcool62merc]

I recently insalled your system on my '61 Buick LeSabre. I have done several other install using your kits but this is the first time I have used shockwaves. When I raise the front, the right side comes off the internal bump stops first and then the left. The right side comes off at about 90 psi and the left at approx 100psi. When lowering, it does just the opposite, the left drops onto the internal bump stop first then the right will drop down. Doing some measurments, when the left finally starts to come up, the right is already up about an inch. What is the recommended ride hieght of the shockwaves used for the 61 Biucks and where (approx) should my front pressur be? Thanks.

[darren@ridetech.com]

Ride height pressure will vary depending on vehicle weight, I was thinking on that car that it would be about 115-120 psi. Ride height should be just over mid travel. When measuring at the fender lip you should have about 5" of travel, so ride height should be about 3" from fully compressed. Whatever pressure it takes to get it to that height is what you should drive it at.