60 chev panhead bar adjustment

[60 Nomad]

Hi new to the forum. I tried a search to no avail. I have no clue how to adjust the panhead bar...need advice..thanks

[darren@ridetech.com]

I assume that you have our StrongArm kit with the adj. panhard bar. With the vehicle at ride height (air spring 5" tall), just center the axle. For example, if the the axle is a 1/2" closer to the fender on the passenger side, then shorten the bar by 1/4".

[Tony@AirRide]

Darren.. I am not sure here but I think he is trying to technically figure out how to adjust it.... besides, I know who this is and he needs all the help he can get. :rolleyes:

[60 Nomad]

Darren.. I am not sure here but I think he is trying to technically figure out how to adjust it.... besides, I know who this is and he needs all the help he can get. :rolleyes:

That was just mean:o. You guys need to spend a little more time with your instructions. You don't even mention what you are adjusting.... pretty vague;). I figured it out with no help from you guys:D. The rears were really easy to install. I had to do some grinding and welding on the fronts. Took a couple of hours. Thanks for the help on the phone Tony...........I'll finish it off tomorrow. I'm also adding 4 wheel disc while I'm at it.....

[60 Nomad]

Here's a couple of pics of the Rear Strong Arms and disc brakes installed. Your stuff bolted right up with no glitches:)

[darren@ridetech.com]

Lookin good!
I'll ignore that comment about the instructions......

[Tony@AirRide]

Darren.... face it man.... some of your instructions are one step under a Revell snap together ;)