air pressure?

[werduhelrwee]

I have an '03 ranger with "what i belive is" the ride pro 1 on it. My question is ever sine I got the truck the pressure on the contoller just shows the pressuer in the tank in all three corners but one. What could this be? other than not showing the right pressure the thing is great.
Thanks,
Barry

[britt@ridetech.com]

First, let's determine what system you have.
Does it look like this (RideProE2/LevelPro):
http://www.ridetech.com/catalog/RidePro_E2-36-1.html
or like this (RideProE1):
http://www.classicperform.com/Store/Air_Ride/CON6000.htm

If you have an E1:
What pressures are being shown? 165psi? Most likely the problem is in the pressure sending units. Almost every issue I've ever had with an E1 was the result of poor ground to the sensors. The best way to fix this is to solder a male spade terminal to each sensor, then daisey chain the grounds together to a single ground on the chassis.

If you'd like a diagram of how to do this, please drop me an e-mail at britt@ridetech.com and I'll forward it along.