second gen level pro install

[sin]

im getting ready to install the level pro sensors on my 80 camaro. do you happen to have any pics of where you installed them on the 71 project. or any good suggestions on where i might mount them.

[darren@ridetech.com]

The black car does not have height sensors on it. On most front ends like this we would normally mount the sensor to the outside of the frame rail, right in front or behind the coil spring pocket. Being a front steer, behind the pocket will most likely have more room. Then attach the link to the upper or lower arm. You will most likely have the shorten the arm a bit too, to unsure you get enough sensor movement.

[darren@ridetech.com]

On the rear I would look at mounting the sensor to the inside of the frame rail, in front of the axle. The attach it to the lower 4 link bar. Depending on how far forward you mount the sensor, you may have to shorten the arm on the back too. Again, I have not installed height sensor on that car, so there may be better options.