samcrf450
08-16-2008, 03:58 PM
What is the bushing # for the universal triangulated 4 links? I welded the upper tabs on the axle and they were tight like they are supposed to be and when I used my rubber mallet to put the link back in the teeth must have grabbed too hard and it broke a little piece on the inner bushing. Also what is the whole threaded link end part # it might be cheaper to just replace that instead of paying to get the bushing pressed out and the new one pressed in. It doesnt appear to be that bad could I just leave it and run it like this?
Also to get some of the brackets to actually pinch on the bushings I had to torque them so much that it bent the brackets is this alright? Or should I put some washers in there. I can send you some pics if you want. I cant upload them here because the images are too big.
Also to get some of the brackets to actually pinch on the bushings I had to torque them so much that it bent the brackets is this alright? Or should I put some washers in there. I can send you some pics if you want. I cant upload them here because the images are too big.