97 S-10

[Norman]

Ive got a 97 S-10 and im going to be running 18" Helo Kick. Im also going to be installing a wings west body kit. I was wondering what the best system would be for me. I just want to be able to raise and lower no hopping or shit required here. I dont want to lay frame or nething like that but id like to go pretty low. HELP :) Thanks

[Norman]

I lied about the truck its a Sonoma i dont know if there is a diffrence at all but I figured id better let ya know. And Id prefer not to cut the truck if I dont have to. Thanks

[Norman]

Ok now I am looking at the Air Bar S-10 for the rear and the Cool Ride for the front and it will be ran by the 2way Ride Pro System. I have a few questions and they are: will these fit on a Sonoma, is the Cool Ride bolt on or weld on, do I need lowering arms or raising arms, and will the front and rear lower level or will the front be higher than the rear or vice versa? Like I said before im not looking to hit bottom here just lower it a few inches from ground. And on another note Id like to lower/raise the same height every time kinda like what the intelli ride does but without being that expensive, is there a setting on the Ride Pro System to do that or do I just have to stop when I get it to the height I want. Any help here would be great. Thank you

[Norman]

Sorry for all the questions but I dont know much about this stuff at all. If I went with the intelli system, the air bar system for the rear, and the cool ride system for the front would I have to buy a Ride Pro or Big Red system or would I be all set. SORRY again and Thanks

[rollinon22s]

Lets see, So many question. First off sonoma / s-10 they' re the same. So yes the air bar would work. In your case I would use the airbar in the rear and the cool ride up front. I would also use the lower control arms. As far as the leveling thing goes.... The air kits come with gauges, so you can set your ride height the same every time you air up the bags. The cool ride is some what bolt on. You will need to weld the shock relocators on. I believe they might even sell the bolt on shock relocators. You will also have to notch the frame so the front bags won' t rub. I think I answered all your question if I missed one let me know and I' ll try to answer it.

[Norman]

Thanks alot for the info. I have one more question, Can I use the Intelli Ride to control the Cool Ride and Air Bars or do I need to buy another system in addition to the intelli ride? Thx

[darren@ridetech.com]

The Intelliride is all you would need. It comes with the valves, tank, compressor, wiring harness, height sensors, switch, and ECU.

[Norman]

Thx for the info guyz!!