Sensor error

[tmrv66]

Good Morning,

Getting an error 1304 on calibration setup. It says that min/max must be over IV before system will work(whatever that means).
Left rear internal shockwave sensor.

Help...

Thanks, Todd

[tmrv66]

I should add:
2004 Mustang
Shockwaves with internal sensors in rear
Struts with external sensors in front.
E3 System, 2gal, 1 compressor

Thanks, Todd

Update:
The trouble follows the e3 lR port.

[britt@ridetech.com]

It means exactly what is says: the voltage change from minimu
to maximum must be over 1volt.

When it asks you to raise to max make sure you raise the car as far as it will go. You can also probe the level sensor wire with a volt meter to make sure it's working. It should have 5V on the red wire, ground on black, and 0-5V on the colored wire.

[tmrv66]

Thanks for the quick response Britt.

The car is raised until the crimp ring is visible.

On another note, Is 3.5" travel enough for thes rear shockwaves ?

The front struts have plenty of travel.

Thanks, Todd

[britt@ridetech.com]

Not sure what shocks are used on that (I'm on the road and can not look it up) but you should see around 5 inches of travel atthe fender lip.

[tmrv66]

3.25" at the fender lip.
5 volts on bat and signal lead.

I'll go ahead and call this in to your shop, since your on the road.

Thanks, Todd