new system question

[40buickcoupe]

I bought the complete E3 system with shockwaves for my Camaro. Two questions why dont you send directions?

If Im not using the level sensors and just air pressure can I cut the GRAY and BLUE wires back and eliminate the connectors with the big red wires? They are bulky and if Im not pluging them in just want to know if I can cut them back and get rid of them

[40buickcoupe]

I meant either gray or blue. Im only using one compressor. Also the wiring diagram does not show the fuseable link.

Should I use a fusable link on the little red wire or the compressor large red wire

[britt@ridetech.com]

Instructions should be in the "Do Not Open" folder.
You can also download them here under the "instructions" tab:
http://www.ridetech.com/store/control-systems/ridepro-e3-digital-4-way-system.html

If you are using only one compressor you can eliminate the Blue wire (it is for the secondary compressor).

Fuses:
Anything connected directly to the battery should have a fuse no more than 18-inches from the battery. This protects the circuit should something go wrong (you don't have a "hot" wire going the length of the car).

The large RED wire is the compressor +12V supply and should be connected and fused at the battery.

The small RED wire is the e3 computer +12V constant supply and can be connected and fused at the battery, or connected to the fuse panel of the vehicle.