nissan

[dragin]

I herd that i can crank the toursion bars on the front of a nissan and it will drop it two inch is this true? Also will it mess with the alignment? I want to put a 3inch block in the back and crank the toursion bars down for a 2/3 drop.

[rollinon22s]

Yeah you can do that. You will have to cut your front bump stops or put some shorter ones in it. Yes it will mess up the alignment. Put some drop spindles on there and get the truck aligned it should be fine. My friend has the same setup. If you want a good ride you need to put bags on it. It will ride like a tank the way you want to do it. Which is fun for about a week.

[dragin]

THE TRUCK IS NOT MINE MAN JSUT DOING IT FOR SOME GUY. WILL THE ALIGNMENT BE OK TO DRIVE FOR AWHILE OR IS IT WAY TO BAD?

[rollinon22s]

Well it is best to get it align. It depends on the truck and how much you crank them down. I say just do it and see. Mark the bars so you can put them back to factory specs if you need to. I still think it will be cheaper to get it align first than to buy new tires down the road. You really don' t need the spindles they just make it ride better. There are other tricks you can use in the rear to get it low also. You can remove a couple of leafs from the leaf springs. The leaf spring mount in the front of the spring can be a pain as well. It hangs down about 3 inch lower than the frame. There is a trick in fixing that as well. But it is kind of hard to explain it by typing. Hope this stuff helps.

[dragin]

thank man it does help alot. will tell u how it rides after all done