Baggin 02 F-150

[Methos]

I am wanting to bag an 02' Ford F-150. I am looking at the Airbar Bolt on 4 link system (ABAR11002) for the back. My question is, will I need to cut into my bed? Most of the truks I have seen the bed and fenders are cut and I want to avoid this if at all possible. Also will this effect how low I can go? Any input would be a great help.

[darren@ridetech.com]

That AirBar is designed for about a 9-10" drop fully deflated. You will not have to cut the bed for axle or notch clearance. We have used up to 20 with this setup with no mods for tire clearance.
Of course you will have to cut for the frame for the C notch and I think there is a little bracket off the spare tire crossmember that needs to be cut off.

[Methos]

Thanks for that. How about the front, will I need dropped spindles or control arms?

[darren@ridetech.com]

Our kit will drop the front about 6" . If you want more you a lot of guys are flipping the ball joints and putting the ball joints on top of the control arms. There is some machining required to the spindles. Talk to Mike at Down-N-Dirty Kustoms in Michigan, I think he is still exchanging spindles and arms that are already prepped.