Announcement

Collapse
No announcement yet.

Ride Pro E control pad only lights 3 of 4

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ride Pro E control pad only lights 3 of 4

    Is this typical that one of the corners is dim on the key pad?

    I am also waiting for my air pressure sending units.

    Any one know if you could hook up ride height sensors from a GMC Danali ?

    They seem to work on the same principal..




  • #2
    RE: Ride Pro E control pad only lights 3 of 4

    No they should all be lit the same. We might have to replace the ECU and controller.

    Comment


    • #3
      RE: Ride Pro E control pad only lights 3 of 4

      The gauges in my system light up evenly. The only problem I' m having is getting them to dim when the lights are on.

      The instructions say to connect the green/black wire to illumination, but it doesn' t say if the illumination connection should be a ground or hot source.

      Comment


      • #4
        RE: Ride Pro E control pad only lights 3 of 4

        Put the wire to the hot source !!! It should work ... ground to ground will do nothing but ........ground!! good luck!

        Comment


        • #5
          RE: Ride Pro E control pad only lights 3 of 4

          I' ve attached the wire to the hot source coming from the light switch... and the panel won' t dim. Any other ideas on what the problem could be?

          Comment


          • #6
            RE: Ride Pro E control pad only lights 3 of 4

            I take it the panel Is now lit?? To make it dim you must find the wire coming off your dimmer switch and connect it to that>> Locate the wires coming off your dimmer switch and connect a 12v test light to each wire, and when the test light " lights up" dim your switch. if the test light dims.. you have found your wire! This is the wire you need to connect to<

            Comment

            Working...
            X